Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

sonet-options

 

Syntax

Hierarchy Level

Release Information

Statement introduced before Junos OS Release 7.4.

Description

Configure SONET/SDH-specific interface properties.

On SONET/SDH OC48 interfaces that you configure for channelized (multiplexed) mode (by including the no-concatenate statement at the [edit chassis fpc slot-number pic pic-number] hierarchy level), the bytes e1-quiet and bytes f1 options have no effect. The bytes f2, bytes z3, bytes z4, and path-trace options work correctly on channel 0 and work in the transmit direction only on channels 1, 2, and 3.

On a channelized OC12 interface, the bytes e1-quiet, bytes f1, bytes f2, bytes z3, and bytes z4 options are not supported. The fcs and payload-scrambler statements are also not supported; you must configure these for each DS3 channel using the t3-options fcs and t3-options payload-scrambler statements. The aps and loopback statements are supported only on channel 0 and are ignored if included in the configurations for channels 1 through 11. You can configure loopbacks for each DS3 channel with the t3-options loopback statement. The path-trace statement can be included in the configuration for each DS3 channel, thereby configuring a unique path trace for each channel.

To configure loopback on channelized IQ and IQE PICs, SONET/SDH level, use the loopback statement local and remote options at the controller interface (coc48, cstm16, coc12, cstm4, coc3, and cstm1). It is ignored for path-level interfaces so-fpc/pic/port or so-fpc/pic/port:channel.

If you are running Intermediate System-to-Intermediate System (IS-IS) over SONET/SDH interfaces, use PPP if you are running Cisco IOS Release 12.0 or later. If you need to run HDLC, configure an ISO family MTU of 4469 on the router.

The remaining statements are explained separately. See CLI Explorer.

Required Privilege Level

interface—To view this statement in the configuration.

interface-control—To add this statement to the configuration.