optical-options (IPLC)

Syntax

Hierarchy Level

Release Information

Statement introduced in Junos OS Releases 15.1F6 and 17.1R1.

Description

Configure the settings for the integrated photonic line card (IPLC). The options under this statement enables you to increase the IPLC channel capacity to 64 channels, configure express in and out traffic from another IPLC base module, create a single two-degree IPLC node, switch express traffic to optical interfaces in the local or remote chassis, optically bypass channels, and fine-tune performance monitors.

Options

slot—Specify the slot number the IPLC resides in.

Range: 0 through 15

disable-edfa—Disable both erbium-doped fiber amplifiers on the IPLC. Disabling the erbium-doped fiber amplifiers on the IPLC is required as a preliminary step whenever the you need to disconnect the fiber span from the

Line
IN

and Line OUT ports for troubleshooting.

disable-osc—Disable the optical supervisory channel laser.

no-disable-edfa—Enable both erbium-doped fiber amplifiers on the IPLC. By default, both erbium-doped fiber amplifiers are enabled.

no-disable-osc—Enable the optical supervisory channel. By default, the optical supervisory channel is enabled.

Best Practice

Anytime you need to disconnect or connect the fiber span from the Line IN and Line OUT ports on the IPLC module, we recommend you disable the optical supervisory channel and the erbium-doped fiber amplifiers on the IPLC.

Always refer to the PTX3000 Packet Transport Router Hardware Guide when connecting or disconnecting cables on the IPLC modules. See PTX3000 Packet Transport Router Hardware Guide.

All other options are explained separately.

Required Privilege Level

interface—To view this statement in the configuration.

interface-control—To add this statement to the configuration.