Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
lcc-mode
Syntax
lcc-mode {lcc lcc_number{mode mode;}}
Hierarchy Level
[edit chassis]
Release Information
Statement introduced in Junos OS Release 13.1 for TX Matrix Plus routers with 3D SIBs.
Description
Set the line-card chassis (LCC) in a routing matrix to function as a T1600 router or a T4000 router. If you set the value of the mode variable as empty, then the line-card chassis goes offline. If the mode statement is not configured, then by default the LCC functions as a T1600 router.
Default
If you do not include the lcc-mode statement, the LCC functions as a T1600 router.
Options
lcc number—On a TX Matrix Plus router, display hardware information
for a specified router (line-card chassis) that is connected to the
TX Matrix Plus router.
Replace number with the following values depending on the LCC configuration:
- 0 through 3, when T640 routers are connected to a TX Matrix router in a routing matrix.
- 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a routing matrix.
- 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D SIBs in a routing matrix.
- 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with 3D SIBs in a routing matrix.
mode mode—Configure the LCC to function as a T1600 or a T4000 router.
The value of the mode variable can be set as t1600, t4000, or empty.
Required Privilege Level
interface-control
