active-leasequery (DHCP Relay Agent)
Statement introduced in Junos OS Release 19.1R1 on MX Series routers.
topology-discover option added in Junos OS Release 19.2R1.
Enable support for active leasequery on a DHCPv4 or DHCPv6 relay agent. You can also configure parameters that the DHCP relay agent uses when sending DHCP active leasequery messages to obtain lease information from the DHCP servers in the logical system/routing instance.
During active leasequery operations, binding information is updated only when it changes. Consequently, there are periods during which the server or peer relay agent sends no information; the connection is idle. If this period is longer than the idle-timeout, the connection is dropped. To avoid inappropriate connection drops, the server or peer relay agent sends DHCPLEASEACTIVE (DHCPv4) or LEASEQUERY-DATA (DHCPv6) messages at intervals equal to one-half of the idle timeout period. These messages contain no binding information because they are sent when no updates are available. These messages keep the connection alive by serving as hello or keepalive messages signaling that the lack of activity is not a problem.
Range: 10 through 3600
You can also achieve 1:1 chassis redundancy with an M:N redundancy configuration where:
You configure redundancy for all DHCP subscribers on the chassis
You configure a single chassis to back up all of the subscriber redundancy groups
Range: 10 through 3600
For dual-stack subscribers, you must configure active leasequery with topology discovery for both DHCPv4 and DHCPv6.
Each peer relay agent sends topology discovery request messages over the TCP connection to each peer relay agent.
The receiving peer returns a topology discovery response message with information about its corresponding access interface.
The querying relay agent then updates its translation table to map the remote (peer) access interface with its local access interface.
Each relay agent peer initiates topology discovery for all of its access interfaces. Each peer then updates its own translation table according the information received in topology discovery responses.
Required Privilege Level
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.