Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Provisioning a Single-Ended Point-to-Point Service

 

You can create a point-to-point link between the end points of a managed device and an unmanaged device. An unmanaged device is a third-party device. In cases where interoperability with a third-party device is necessary, Junos Space allows you to define the link between a Juniper Networks managed device and the third-party device. You need to specify the IP address and the end point interface name of the unmanaged device. The Junos Space does not validates the information of an unmanaged device. You cannot configure an unmanaged device. The Junos Space pushes the configuration only to managed device.

To create a point-to-point link to an end point that is not managed by Junos Space, in the Network Activate task pane, select Service Provisioning> Manage Service Orders> Create P2P Service Orders. The Create P2P Service Orders page displays an inventory of all available point-to-point service definitions.

  1. Select the service definition upon which you want to base your service order, and click Next.
  2. Specify the general/connectivity settings. For details on creating a point-to-point service order, see Creating a Point-to-Point Service Order
  3. Click Next to specify the endpoint settings.

    • If this end point is N-PE device, select a device from the PE Device. Configure the endpoint settings as mentioned in Creating a Point-to-Point Service Order

    • If this endpoint is a third-party device, select Unmanaged device from the PE Device.



      Fill in the fields as indicated in the table:

      Field

      Actions

      PE Device

      Since the endpoint is a third-party device, select Unmanaged device from the list.

      Loopback IP Address

      Specify the loopback IP address of the third-party device.

      Range: 127.0.0.0 through 127.255.255.255

      Unmanaged Interface

      Specify the end point interface name of the unmanaged device, which is the third-party device.

  4. Click Next to specify another endpoint settings. Note

    Both the endpoints cannot be a third-party device.

  5. To finish creating the service order, click Create.
Note

The functional audit is performed only on the Juniper Networks devices (managed devices). To perform a successful functional audit of an unmanaged device, configure the following attributes of an unmanaged device:

  • Neighbor IP

  • Virtual circuit ID

  • Unit ID

  • Encapsulation

  • Filter

  • Policer

Related Documentation