Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Stopping the Disaster Recovery Process

 

You stop the disaster recovery process from the active site or the standby site when you need to update the disaster recovery configuration or add nodes or applications to the disaster recovery setup. You use the jmp-dr stop command to stop the disaster recovery process on both sites. Stopping the disaster recovery process does not clean up the disaster recovery configuration from the sites.

The jmp-dr stop command does the following:

  • Stops the disaster recovery watchdog at the sites

  • Stops the replication of MySQL data, PgSQL data, configuration files, and round-robin database (RRD) files between sites

We recommend that you execute the jmp-dr health command at both sites after you stop the disaster recovery process. This is to ensure that file replication, disaster recovery watchdog services, and other services are stopped. For more information, see Checking the Status of the Disaster Recovery Configuration.

To stop the disaster recovery process at both sites:

  1. Log in to the CLI of the Junos Space node at the active site on which the VIP or the eth0:0 interface is configured.

    The Junos Space Settings Menu is displayed.

  2. Enter 6 (if you are using a hardware appliance) or 7 (if you are using a virtual appliance) at the Junos Space Settings Menu prompt to run shell commands.

    The following is a sample output from a virtual appliance:

    You are prompted to enter the administrator password.

  3. Enter the administrator password.
  4. Type jmp-dr stop at the shell prompt and press Enter.

    The following is a sample output:

The disaster recovery process is stopped.