Help Center User GuideGetting StartedFAQRelease Notes
 
X
User Guide
Getting Started
FAQ
Release Notes
Contents  

Installation and Upgrade Instructions


This section contains the procedures to install and upgrade Junos Space Security Director and Log Collector.

Installing and Upgrading Security Director Release 18.2R1

Junos Space Security Director Release 18.2R1 is supported only on Junos Space Network Management Platform Release 18.2R1 that can run on the following devices:

In Junos Space Security Director Release 18.2R1, a single image installs Security Director, Log Director, and the Security Director Logging and Reporting modules. All three applications are installed when you install the Security Director Release 18.2R1 image.

Note: From Junos Space Security Director Release 17.2R1 onward, Log Collector version information is stored in the /etc/juniper-release file on the Log Collector. In previous Junos Space Security Director releases, Log Collector version information is stored in the /etc/redhat-release file on the Log Collector.

Note: Integrated Log Collector on a JA2500 appliance or Junos Space virtual appliance supports only 500 eps.

For more information about installing and upgrading Security Director Release 18.2R1, see Security Director Installation and Upgrade Guide.

Adding Security Director Log Collector Node in Security Director Release 17.2R1 and Later

For distributed deployment, you can add only Log Receiver node in Security Director and cannot add Log Storage node. You can add the node directly to Security Director using admin credentials, as in the case of the JSA node. For security reasons, non-root credentials are used to add a node.

Note: For Security Director Log Collector, provide the default credentials: Username is admin and Password is juniper123. You must change the default password by using the Log Collector CLI command configureNode.sh as shown in Figure 1.

Figure 1: Change Password

Change Password

For JSA, provide the admin credentials that is used to login to the JSA console.

For information about how to add the Log Collector node to Security Director, see Security Director Installation and Upgrade Guide.

Help us to improve. Rate this article.
Feedback Received. Thank You!

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit