Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Specifying Connectivity Information When Signaling Is LDP

 

The fields displayed in the Connectivity page depend on the Signaling type (LDP or BGP) that you selected in the General settings page.

To specify connectivity between sites across the network when signaling is LDP:

  1. Fill in the fields in the Connectivity page.

    Field

    Action

    VC ID selection

    The VC ID selection is available only if the Signaling type is LDP.

    In the VC ID selection box, specify how you want the VC ID to be chosen during service order creation:

    • To allow the service provisioner to enter the VC ID, choose Select manually.

    • To cause the Junos Space software to assign a VC ID automatically from the VC ID pool, select Auto pick.

    To allow the service provisioner to override the setting in the VC ID box, select Editable in Service Order.

    Default MTU

    In the Default MTU box, specify the MTU across the service provider network.

    To allow the service provisioner to override the MTU setting, select Editable in Service Order. In the MTU range, enter the highest and lowest MTU that the service provisioner can enter.

    Revert time (sec)

    This field is available if you selected the Enable PW Resiliency check box and if the Signaling is LDP in the General settings.

    Revert time (sec)—Revert time for redundant Layer 2 circuits and VPLS pseudowires.

    Default: 5 seconds

    Range: 0 through 65,535 seconds

    Switch Over Delay (sec)

    This field is available if you selected the Enable PW Resiliency check box and if the Signaling is LDP, in the General settings.

    Switch Over Delay (sec)—Delay to wait before the backup pseudowire takes over.

    Default: 0 second

    Range: 0 through 180 seconds

    VLAN Normalization

    The options available in the VLAN normalization are based on the value set for the Ethernet interface.

    Outgoing label selection

    This field is available if you selected the Static pseudowire check box in the General settings. By default, the outgoing label selection is limited to manual.

    The following table presents the available VLAN normalization options:

    Ethernet Option

    Customer Traffic Type

    VLAN Normalization

    port-port

    N/A

    Normalization not required

    Normalization to Dot1q tag

    Normalization to QinQ tags

    dot1q

    Transport single vlan

    Swap

    Normalize to None

    Normalization to Dot1q tag

    Normalization to QinQ tags

     

    Transport vlan range

    Normalization not required

    qinq

    Transport all traffic

    Swap

    Normalize to None

    Normalization to Dot1q tag

    Normalization to QinQ tags

     

    Transport single vlan

    Swap

    Normalize to None

    Normalization to Dot1q tag

    Normalization to QinQ tags

     

    Transport vlan range

    Normalization not required

    Asymmetric

    (Identical to qinq)

    (Identical to qinq)

  2. Click Finish to complete the service definition.