Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Specifying Connectivity Information When Signaling Is LDP

    The fields displayed in the Connectivity window depend on the Signaling type (LDP or BGP) that you selected in the General settings window.

    To specify connectivity between sites across the network when signaling is LDP:

    1. Fill in the fields in the Connectivity window.

      Field

      Action

      VC ID selection

      The VC ID selection is available only if the Signaling type is LDP.

      In the VC ID selection box, specify how you want the VC ID to be chosen during service order creation:

      • To allow the service provisioner to enter the VC ID, choose Select manually.
      • To cause the Junos Space software to assign a VC ID automatically from the VC ID pool, select Auto pick.

      To allow the service provisioner to override the setting in the VC ID box, select Editable in Service Order.

      Default MTU

      In the Default MTU box, specify the MTU across the service provider network.

      To allow the service provisioner to override the MTU setting, select Editable in Service Order. In the MTU range, enter the highest and lowest MTU that the service provisioner can enter.

      Revert time (sec)

      This field is available if you selected the Enable PW Resiliency check box and if the Signaling is LDP in the General settings.

      Revert time (sec)—Revert time for redundant Layer 2 circuits and VPLS pseudowires.

      Default: 5 seconds

      Range: 0 through 65,535 seconds

      Switch Over Delay (sec)

      This field is available if you selected the Enable PW Resiliency check box and if the Signaling is LDP, in the General settings.

      Switch Over Delay (sec)—Delay to wait before the backup pseudowire takes over.

      Default: 0 second

      Range: 0 through 180 seconds

      VLAN Normalization

      The options available in the VLAN normalization are based on the value set for the Ethernet interface.

      Outgoing label selection

      This field is available if you selected the Static pseudowire check box in the General settings. By default, the outgoing label selection is limited to manual.

      The following table presents the available VLAN normalization options:

      Ethernet Option

      Customer Traffic Type

      VLAN Normalization

      port-port

      N/A

      Normalization not required

      Normalization to Dot1q tag

      Normalization to QinQ tags

      dot1q

      Transport single vlan

      Swap

      Normalize to None

      Normalization to Dot1q tag

      Normalization to QinQ tags

       

      Transport vlan range

      Normalization not required

      qinq

      Transport all traffic

      Swap

      Normalize to None

      Normalization to Dot1q tag

      Normalization to QinQ tags

       

      Transport single vlan

      Swap

      Normalize to None

      Normalization to Dot1q tag

      Normalization to QinQ tags

       

      Transport vlan range

      Normalization not required

      Asymmetric

      (Identical to qinq)

      (Identical to qinq)

    2. Click Finish to complete the service definition.

    Modified: 2017-01-19