ADMINISTRATION PORTAL
Help Center User GuideGetting StartedFAQsRelease Notes
 
X
User Guide
Getting Started
FAQs
Release Notes
Contents  

Understanding Wireless Interference

Wi-Fi interference is a common and troublesome issue. The lack of wires that makes WLAN so attractive is also the feature that makes other consumer devices capable of causing Wi-Fi interference. Your WLAN network might be working fine one day and sluggish the next day, without you having made any network changes, all due to interference.

This topic describes:

What Causes Wireless Radio Frequency Interference?

Because the air is shared by all transmitters, transmissions by any device at the same frequency as an access point's radio can cause interference. Because 802.11 wireless networks operate in unlicensed bands used by many technologies, such as microwave ovens, video surveillance cameras, cordless phones, they are subject to interference. In addition, wireless access points sharing the same channel might interfere with each other. The effect of interference is highly dependent on the strength of the transmission and the distance from the interferer. Access points closest to and on the same channel as an interferer will be affected more than those that are further away.

These are some common causes of wireless interference:

Effects of Interference Seen by Clients

Your network clients might notice the results of interference before you do. They might complain of network slowdown, but not of data loss. This slowdown might not be immediately obvious with low capacity data transmission because, if interference is intermittent, packets eventually get through. Therefore, there is no packet loss, just retransmissions that take time. Another possibility is that some devices, such as microwaves, reduce throughput without blocking it entirely. Complaints will increase when more users log in, increasing data capacity until data loss occurs, or when Voice Over IP calls are placed. VoIP requires significant bandwidth because resending voice is not an option—the result is dropped or jittery voice transmission.

You Can Monitor RF Interference with Network Director

Network Director includes a Monitor Mode that displays the compiled RF data gathered by scanning the mobility domain of your network. There are two monitors that indicate network interference for access points and radios:

What Is RF Jamming?

RF jamming is a DoS attack. The goal of RF jamming is to take down an entire WLAN by overwhelming the radio environment with high-power noise. A symptom of an RF jamming attack is excessive interference. If an access point radio detects excessive interference on a channel, and channel auto-tuning is enabled, the radio changes to a different channel. The radio continues to scan on an active data channel and on other channels and reports the results to the controller.

Jamming occurs at the physical layer of the network, saturating the channel or band with noise and making it difficult or impossible for a receiving radio to detect a real transmission. Think of jamming as trying to hear someone talking as a siren goes off. The increased noise floor results in a poor signal-to-noise ratio (SNR), usually detected by the clients as poor signal quality. Jamming can also be detected by an access point, which then triggers dynamic temporary tuning of the channel if automatic channeling is enabled. However, selecting a different channel does not always stop jamming. An experienced attacker will often use all available channels in the attack.

Related Documentation

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit