ADMINISTRATION PORTAL
Help Center User GuideGetting StartedFAQsRelease Notes
 
X
User Guide
Getting Started
FAQs
Release Notes
Contents  

Understanding Auto AP Profiles

If you set up an Auto AP profile for a wireless controller, discovered distributed access points that are not specifically configured on that controller use a temporary configuration from the Auto AP profile. When you set up an Auto AP profile for these distributed access points, you provide only the basic information that an access point needs to operate. Auto AP access points do not include all the information that individually configured access points do. In addition, these Auto AP access point configurations are not persistent on the controller—they go away when the access points are not present.

Note: A controller can have only one Auto AP profile.

This topic describes:

How Are Specifically Configured Access Points Different from Access Points Configured with Auto AP?

Controllers give preference to specifically configured, persistent access points over those access points using an Auto AP profile. If a configured access point is discovered by a fully utilized controller, the controller disconnects an access point using an Auto AP profile and accepts connection from the configured access point instead.

In this case, the disconnected access point begins the boot process again to find another controller with an Auto AP profile. When the access point is disconnected, the access point clients experience a service disruption, and attempt to associate with another available access point to reconnect to the SSID. If another access point is not available to a client, the client can still reconnect after the disconnected access point locates a new controller and finishes the boot and configuration process.

How Should I Use Auto AP Profiles?

The Auto AP feature is useful when you need to add multiple access points all at once. Typical use of the Auto AP profile would be to:

How Does Auto AP Work?

When an Auto AP profile is assigned to a controller, the controller assigns a valid number and a name to unassigned, distributed access points. The controller also configures the access point settings and radio parameter settings supplied in the Auto AP profile.

Note: The Auto AP profile does not configure SSIDs, encryption parameters, or any other parameters managed by the WLAN Service profile. You still need to configure a WLAN Service profile for each SSID.

Related Documentation

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit