Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Changing a Transport Profile

    This procedure describes how to use maintenance mode to change a transport profile. You must first halt new sessions from being started and verify that there are no active sessions remaining.

    To change a transport profile:

    1. Enter configuration mode in the CLI.
      user@host> configure
    2. Activate maintenance mode for a charging transport profile:
      user@host# set unified-edge gateways ggsn-pgw gw-name charging transport-profiles profile-name service-mode maintenanceuser@host# commit
    3. Verify that the charging gateway is in maintenance mode.
      user@host# run show unified-edge ggsn-pgw charging service-mode transport-profile profile-name gateway gw-name

      Note: The service mode for the transport profile shows Maintenance – Active Phase if all the sessions using this profile are cleared. The service mode for a transport profile shows Maintenance – In Phase if there are some sessions actively using this profile. The service mode for the profile shows Maintenance – Out Phase if maintenance mode is not configured (that is, it is in operational mode).

    4. Verify that there are no subscribers active on this charging profile.
      user@host# run show unified-edge ggsn-pgw subscribers charging transport-profile profile-name gateway gw-name
    5. (Optional) Terminate sessions using the clear command.
      user@host# run clear unified-edge ggsn-pgw subscribers charging transport-profile profile-name gateway gw-name
    6. When the subscriber count is zero and all sessions have ended, you can make and commit changes to the charging transport profile in active maintenance mode.

      Note: These modifications must be made in active maintenance mode or they will fail.

    7. Modify the charging transport profile as required.
    8. Exit maintenance mode and commit.
      user@host# delete unified-edge gateways ggsn-pgw gw-name charging transport-profile profile-name service-mode commit
    9. Verify that changes were properly committed.
      user@host# run show configuration unified-edge ggsn-pgw gateway gw-name
    10. Return the gateway to operational state.
      user@host# run show unified-edge ggsn-pgw gateway service-mode

    Published: 2011-11-16