Cisco CatOS for Catalyst Switches
The Cisco CatOS for Catalyst Switches DSM for JSA accepts events by using syslog.
JSA records all relevant device events. Before you configure a Cisco CatOS device in JSA, you must configure your device to forward syslog events.
Configuring your Cisco CatOS device to forward syslog events.
Take the following steps to configure your Cisco CatOS device to forward syslog events:
- Log in to your Cisco CatOS user interface.
- Type the following command to access privileged EXEC mode:
- Configure the system to timestamp messages:
set logging timestamp enable
- Type the following command with the IP address of JSA:
set logging server <IP address>
- Limit messages that are logged by selecting a severity
set logging server severity <server severity level>
- Configure the facility level to be used in the message.
The default is local7.
set logging server facility <server facility parameter>
- Enable the switch to send syslog messages to the JSA.
set logging server enable
You are now ready to configure the log source in JSA.
Syslog Log Source Parameters for Cisco CatOS for Catalyst Switches
If JSA does not automatically detect the log source, add a Cisco CatOS for Catalyst Switches log source on the JSA Console by using the syslog protocol.
When using the syslog protocol, there are specific parameters that you must use.
The following table describes the parameters that require specific values to collect syslog events from Cisco CatOS for Catalyst Switches:
Table 1: Syslog Parameters for the Cisco CatOS for Catalyst Switches DSM
Log Source name
Type the name of your log source.
Log Source Identifier
Type the IP address or host name for the log source.
The identifier helps you determine which events came from your Cisco CatOS for Catalyst Switch device.