Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Supported Adapters

 

JSA Risk Manager integrates with many manufacturers and vendors of security products.

The following information is provided for each supported adapter:

Supported versions

Specifies the product name and version supported.

Supports neighbor data

Specifies whether neighbor data is supported for this adapter. If your device supports neighbor data, then you get neighbor data from a device by using Simple Network Management Protocol (SNMP) and a command-line interface (CLI).

SNMP discovery

Specifies whether the device allows discovery by using SNMP.

Devices must support standard MIB-2 for SNMP discovery to take place, and the device's SNMP configuration must be supported and configured correctly.

Required credential parameters

Specifies the necessary access requirements for JSA Risk Manager and the device to connect.

Ensure that the device credentials configured in JSA Risk Manager and in the device are the same.

If a parameter is not required, you can leave that field blank.

To add credentials in JSA, log in as an administrator and use Configuration Source Management on the Admin tab.

Connection protocols

Specifies the supported protocols for the network device.

To add protocols in JSA, log in as an administrator and use Configuration Source Management on the Admin tab.

Required commands

Specifies the list of commands that the adapter requires to log in and collect data.

To run the listed commands on the adapter, the credentials that are provided in JSA Risk Manager must have the appropriate privileges.

Files collected

Specifies the list of files that the adapter must be able to access. To access these files, the appropriate credentials must be configured for the adapter.