Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring a DCN DCS/DCRS Series Switch

 

To collect events, you must configure your DCN DCS/DCRS Series switch in JSA.

  1. Log in to your DCN DCS/DCRS Series Switch command-line interface (CLI).
  2. Type the following command to access the administrative mode:

    enable

  3. Type the following command to access the global configuration mode:

    config

    The command-line interface displays the configuration mode prompt:

    Switch(Config)#

  4. Type the following command to configure a log host for your switch:

    logging <IP address> facility <local> severity <level>

    Where:

    • <IP address> is the IP address of the JSA console.

    • <local> is the syslog facility, for example, local0.

    • <level> is the severity of the syslog events, for example, informational. If you specify a value of informational, you forward all information level events and later (more severe), such as, notifications, warnings, errors, critical, alerts, and emergencies.

    For example,

    logging 10.10.10.1 facility local0 severity informational

  5. Type the following command to save your configuration changes:

    write

    The configuration is complete. You can verify the events that are forwarded to JSA by viewing events in the Log Activity tab.