Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Adding Primary Tunnels

    To switch to modify mode, click on “Modify” mode button. The Modify pull-down menu gets activated.

    Select Modify > Elements > Tunnels from the Modify pull-down menu. In the Tunnels window, click Add and select One Tunnel. The Add Tunnel window is displayed as shown in Figure 1.

    Figure 1: Add Tunnel Window

    Add Tunnel Window

    In the Properties tab, specify a TunnelID, the BW (bandwidth) for the tunnel, and the Pri,Pre (setup priority/holding priority) fields. Also select the source and destination nodes (Node A and Node Z).

    In the Paths tab, Note the different ways of configuring a path under the To choose paths field.

    Figure 2: Different Methods of Choosing Paths

    Different Methods of Choosing Paths

    How to specify a configured and/or dynamic route is described later in this chapter.

    After you have specified your route, click “Add” to add the tunnel. A yellow line between the source and destination will be drawn on the map to represent the logical tunnel. Note that the routing of the tunnel has not been performed yet.

    Modified: 2016-11-08