ON THIS PAGE
Configuring NTP over IPv6 on CTPView Server (CTPView)
Following are the pre-requirements for configuring NTP over IPv6 on CTPView:
CTPView should be configured to either “IPv6 only” or “IPv4 and IPv6” protocol as shown below:
Hostname: ctpview Domain: (none) Protocols supported: IPV4 & IPV6 Default network device (eth0: ) IPV4 parameters: ipaddress: 10.216.118.98 netmask: 255.255.254.0 default gw: 10.216.119.254 mtu: 1500 bytes Default network device (eth0: ) IPV6 parameters: ip6addr: 2001:418:9802:ffee::98/48 ip6mtu: 1500 bytes ipv6gw: 2001:418:9802:ffee::1
The NTP server should be configured with an IPv6 address.
This section contains the following topic:
Configuring NTP over IPv6 on CTPView
To configure NTP over IPv6 on CTPView:
- In the side pane, select Server > Administration. The Administrative Functions pane is displayed.
- Click NTP Server Configuration. The NTP Server Settings window is displayed.
- Under the Manage NTP Peers section,
enter the IPv6 address of NTP server, and then click Add New NTP Peer.
A popup of “Successfully added peer” is displayed.
- Click OK and wait for 3 to
5 minutes. Then, click Refresh Page.
Under the Summary of NTP Servers Peers section, verify that the CTPView server is synchronized successfully with the added NTP server.
- You can also manually synchronize CTPView server with
NTP server by selecting the already added NTP peer from the Select a peer to manually sync to: list and then clicking
the Sync to Selected Peer button.
After clicking Sync to Selected Peer, a popup of “The CTPView server clock has been manually synchronized to peer” should be displayed. Wait for 3 to 5 minutes, and then click the Refresh Page button. Under the Summary of NTP Servers Peers section, verify that CTPView server is synchronized successfully with the added NTP server.