Configuring 4WTO Daughter Cards to Interoperate with Multiservice Interface Modules (CTP Menu)
To interoperate with Multiservice Interface modules, your 4WTO daughter card must have firmware revision 4 or higher and you must be using CTPOS 6.0 or higher.
Interoperability of Multiservice Interface modules with 4WTO daughter cards requires the following:
Firmware revision 4 or higher on the 4WTO daughter card.
CTPView releases 3.4R4 or 4.x.
CTPOS release 6.0 or higher.
Channel 1 cannot be the enabled channel.
When you enable interoperability of the 4WTO daughter card with Multiservice Interface modules, the port speed for the bundle is set as follows:
64 when only channel 0 is enabled.
128 when dual channel is enabled.
Before you begin:
Disable the bundle before you modify the bundle options.
To configure 4WTO daughter cards to interoperate with Multiservice Interface module using the CTP Menu:
- From the Main Menu, select 1) Bundle Operations.
- Select 1) CTP.
- Select a bundle from the list. The bundle port must have
a 4WTO daughter card installed.
If you select an active bundle, you are prompted to disable the bundle before configuring it.
- Select 3) Port Config.
- Select 2) Interface.
- Select 1) Type, and set the type to Optional Interface: Voice 4W/TO.
- Follow the onscreen instructions.
- Configure the Ms interwork option as described in Table 10.
Enables or disables interoperability of the 4WTO daughter card with Multiservice Interface modules.