Configuring T1 and E1 Port Parameters for CESoPSN Bundles (CTPView)
This topic describes how to configure port parameters for T1/E1 interfaces.
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure T1 and E1 port parameters using CTPView:
- In the side pane, select Bundle > Configuration.
- Run your mouse over the Display and Select an Existing Bundle bar.
- In the table of bundles, select the bundle that you want to modify.
- Under Port Options, configure
the parameters described in Table 12.
The options vary depending on whether the bundle is T1 or E1.
- Click Click to Submit Bundle AND Port Changes.
Table 12: CESoPSN Bundle T1 and E1 Port Parameter Settings in CTPView
Specifies a description for the port.
Enter a description of up to 62 alphanumeric characters. Do not use the following characters:
( ; ' " ) ]
Specifies the type of interface.
The type of interface that you select affects the default packet size and buffer sizes for the bundle.
T1 Line Coding
For T1 interfaces, specifies the T1 encoding method used on this bundle.
E1 Connector Type
For E1 interfaces, the termination is configured to work with HDB3.
For T1 interfaces, specifies the line buildout.
Frame Mode (for T1 )
Specifies the frame format to be used for T1 interfaces.
For T1 interfaces, specifies whether or not CAS signaling is used.
E1 interfaces support both CCS and CAS.
For T1 interfaces, select one:
For E1 interfaces, select one:
Specifies the type of clocking for the port.