TechLibrary

Navigation Back up to About Overview

[+] Expand All

[-] Collapse All

Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3
- Copyright and Trademark Information
- Table of Contents
- Overview
  - Overview of CTP Bundles
    - Types of Bundles Overview
    - Interface Naming Conventions for the CTP Series
    - Serial Multiservice Interface Module Overview
    - Adaptive Clocking Overview for CTP Bundles
    - Determining Optimal Packet Size for CTP Bundles Overview
    - Providing QoS for CTP Bundles by Using Service Type Overview
    - Circuit Startup Process Overview
    - Transparent Encoding Overview
    - TDM/TDC Encoding Overview
- Configuring CTP Bundles
- Administration
  - Activating, Disabling, Deleting, or Recentering CTP Bundles
    - Activating, Disabling, Deleting, or Recentering CTP Bundles (CTPView)
    - Activating, Disabling, Deleting, or Recentering for CTP Bundles (CTP Menu)
  - Querying CTP Bundles
  - Monitoring Packet Creation and Reception and Packet Delay for CTP Bundles
    - Using SCC Counts to Monitor Packet Creation and Reception for CTP Bundles (CTP Menu)
    - Using Buffer Sampling to Monitor Packet Delay for CTP Bundles (CTP Menu)
  - Diagnostic Testing for CTP Bundles Overview
    - Serial Loops for CTP Bundles Overview
    - BERT Testing for CTP Bundles Overview
    - End-to-End BERT for CTP Bundles Overview
  - Configuring Diagnostic Testing for CTP Bundles
  - Displaying BERT Status and Counters for CTP Bundles
    - Displaying BERT Status and Counters for CTP Bundles (CTPView)
    - Displaying BERT Status and Counters for CTP Bundles (CTP Menu)
  - Reducing the Number of SNMP Traps Generated for Late and Missing Packets
    - Reducing the Number of SNMP Traps Generated for Late and Missing Packets (CTP Menu)

Download This Guide

Download this guide: Using Bundles to Create Logical Configurations for Physical Interfaces, CTP Release 7.3, CTPView Release 7.3

Interface Naming Conventions for the CTP Series

In the CTP software, interfaces are specified in the format:

type-slot/port

where

type—Type of interface. A two-character abbreviation.

slot—Slot number on the CTP device.

port—Port number on the CTP device.

If the interface module has a daughter card installed, the interface format is as follows:

type-slot/port w/daughter-card

Table 2: Interface Type Specifiers

Interface Type	Type Specifier
4WE&M	4w
4WTO	4w
E1	e1
2W-FXO	fo
2W-FSX	fs
IRIG	irig
Serial	se
T1	t1
T1E1	t1e1

TechLibrary

Download This Guide

Interface Naming Conventions for the CTP Series

Modified: 2018-01-29