Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring 4WTO Daughter Cards to Interoperate with Multiservice Interface Modules (CTPView)

    Interoperability of Multiservice Interface modules with 4WTO daughter cards requires the following:

    • Firmware revision 4 or higher on the 4WTO daughter card.
    • CTPView releases 3.4R4 or 4.x.
    • CTPOS release 6.0 or higher.
    • Channel 1 cannot be configured as the channel option.

    When you enable interoperability of the 4WTO daughter card with Multiservice Interface modules, the port speed for the bundle is set as follows:

    • 64 when only channel 0 is enabled.
    • 128 when dual channel is enabled.

    Before you begin:

    • Log in to the CTPView software at least at the Net_Admin level.
    • Connect the CTPView server to the CTP device for which you want to configure bundles.

    To configure 4WTO daughter cards to interoperate with Multiservice Interface module using CTPView:

    1. In the side pane, select Bundle > Configuration.
    2. Run your mouse over the Display and Select an Existing Bundle bar.
    3. In the table of bundles, select the bundle that you want to modify.
    4. Under Port Options, configure the MS Interwork parameter as described in Table 1.
    5. Click Click to Submit Bundle AND Port Changes.

    Table 1: CTP Bundle 4WTO Interoperability Parameter Setting in CTPView

    FieldFunctionYour Action

    MS Interwork

    Enables or disables interoperability of the 4WTO daughter card with Multiservice Interface modules.

    • ENABLED—Interoperability with the Multiservice Interface module is enabled.
    • DISABLED—Interoperability with the Multiservice Interface module is disabled.

    Modified: 2011-03-09