Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Serial Loops for CESoPSN Bundles Overview

    You can use serial loops to diagnose issues in your network. You set up serial loops in the following directions:

    • Toward the serial interface and the attached customer device.
    • Toward the IP network and the remote customer device.

    Serial loops may not run on transparent circuits. The serial loop function connects the SD and RD signals of the interface (in the direction specified), and will work only if a transparent circuit uses the SD and RD signals to transport data.

    Note: Runtime diagnostics is not supported for CESoPSN bundles configured over analog ports.

    Normal Data Flow in the CTP Network

    Figure 1 shows the normal data flow through the network.

    Figure 1: Normal Data Flow

    Normal Data Flow

    Serial Loop to the Serial Interface

    Figure 2 shows the data flow for a serial loop to the interface and the local customer device.

    The serial loop toward the interface loops data arriving from the serial interface that is destined for the IP network back to the serial interface. The data is still transmitted from the serial interface to the IP network, but data from the IP network to the serial interface is blocked.

    Figure 2: Serial Loop to the Interface

    Serial Loop to
the Interface

    Serial Loop to the Network

    Figure 3 shows the data flow for a serial loop toward the network.

    Serial loops toward the IP network loops data arriving from the IP network that is destined for the serial interface back to the IP network and the remote customer device. The data is still transmitted from the IP network to the serial interface, but data from the serial interface to the IP network and the remote customer device is blocked.

    Figure 3: Serial Loop to the Network

    Serial Loop to
the Network

    Modified: 2014-10-01