TechLibrary

Navigation Back up to About Overview

ContentIndex

[+] Expand All

[-] Collapse All

Managing CTP Devices
- Copyright and Trademark Information
- Table of Contents
- Managing CTP Devices Overview
  - Synchronizing CTP Devices Using External Clocks Overview
  - Ethernet Media Configuration Overview
- Configuring the CTP Device
  - Configuring the Date and Time on CTP Devices (CTP Menu)
  - Configuring a Default Ethernet Interface (CTP Menu)
  - Adding a VLAN Interface to a Node (CTP Menu)
    - Adding a VLAN ID to the System
    - Configuring VLAN Interface by Using the VLAN ID
  - Separate Interfaces for Management and Circuit Traffic Overview
    - Operations Performed When Management and Circuit Traffic Are Segregated
  - Configuring Separate Interfaces for Management and Circuit Traffic (CTP Menu)
  - Displaying the Management and Circuit Interface Settings (CTP Menu)
  - Loss Of Signal Detection Capability on CTP Bundles and SAToP Bundles
    - Detection of LOS on Serial Interfaces
    - Detection of T1/E1 Interfaces
  - Guidelines for Configuring LOS Detection
  - Configuring LOS Detection on CTP and SAToP Bundles (CTP Menu)
  - Initializing the CTP Database (CTP Menu)
  - Pinging an IP Address (CTP Menu)
  - Specifying a Traceroute IP Address (CTP Menu)
  - SSH to Another Host (CTP Menu)
  - Configuring the CTP Bundle Data Packet Protocol and OAM Port (CTP Menu)
  - Rebooting a Node (CTP Menu)
  - Powering Off the CTP Platform
  - Displaying Ethernet Media Information (CTP Menu)
  - Configuring Ethernet Media (CTP Menu)
  - NTP Authentication Overview on CTP Devices
    - NTP Authentication Procedure
  - Configuring NTP Authentication Using the System Query Page (CTPView)
  - Support for Multiple Master Nodes to Associate With a Single Backup Node in NetRef
  - Configuring NetRef Multiple Master Nodes (CTP Menu)
  - Unlocking User Accounts for Which Password Has Expired
    - Script to Monitor the Duration of Inactivity of User Accounts
    - Script to Reset the Expired User Accounts

No index entries found.

Download This Guide

Download this guide: Managing CTP Devices

Ethernet Media Configuration Overview

You can configure the CTP Ethernet media to autonegotiate and set the speed to either 100 or 10 Mbps. By default, autonegotiation is enabled and the speed is to 1000 Mbps. If you choose to disable autonegotiation, the system prompts you to configure the desired speed.

The Ethernet configurations on CTP must match the configuration of the connected router or switch. Mismatched configurations, such as setting the CTP system to autonegotiate and the router to full duplex, will result in a misconfiguration and dropped packets. You must disable Cisco Discovery Protocol on the Fast Ethernet port connected to the CTP system.

Table 1 lists the valid Ethernet media configuration settings that CTP Series supports.

Table 1: Valid Ethernet Media Configuration Settings for CTP

Speed	Autoneg Status	Mode (Duplex)	MTU (up to 1500)
1000	ON	Full	any
100	OFF	Full	any
10	OFF	Full	any

Note: The CTP system supports only full duplex mode.

TechLibrary

Download This Guide

Related Documentation

Ethernet Media Configuration Overview

Related Documentation

Modified: 2015-11-17