Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation  Back up to About Overview 
ContentIndex
  
[+] Expand All
[-] Collapse All

No index entries found.

Configuring Virtual IP Parameters for CTP Bundles (CTPView)

The virtual IP parameters allow you to use a separate IP address for each bundle and to use an address that is different from the IP address for the CTP device. If you configure the IP address on the:

  • Same subnet as the CTP IP address, you do not need a static route on the router.
  • Different subnet as the CTP IP address, you need a static route on the router.

Before you begin:

  • Log in to the CTPView software at least at the Net_Admin level.
  • Create a list of the virtual IP addresses that will be associated with the CTP device. To do so, select Node > Maintenance > Configure CTP Device Virtual IPs, and follow the instructions on the pane. You can create up to 56 virtual IP addresses.

    When you submit your new configuration, the CTP device reboots.

  • Connect the CTPView server to the CTP device for which you want to configure bundles.

To configure virtual IP parameters for CTP bundles using CTPView:

  1. In the side pane, select Bundle > Configuration.
  2. Run your mouse over the Display and Select an Existing Bundle bar.
  3. In the table of bundles, select the bundle that you want to modify.
  4. Under Bundle Options, select Advanced Options Show to display advanced parameters and configure the parameters as described in Table 13.

  5. Click Click to Submit Bundle AND Port Changes.

Table 13: CTP Bundle Virtual IP Parameter Settings in CTPView

FieldFunctionYour Action

Use Virtual IP

Specifies whether or not the bundle uses an address that is different from the IP address of the CTP device.

The virtual IP address is used in the IP packet’s Origination Address field, and is used for the circuit’s data and OAM flow.

Select one:

  • DISABLED—Circuits created by this bundle use the IP address of the CTP device.
  • ENABLED—Circuits created by this bundle use an address that is different from the CTP device.

Virtual IP [ IPv4 only ]

Specifies the virtual IP address for circuits created by this bundle.

Enter the virtual IP address.

At the remote end of the bundle, specify this IP address as the Remote Address of the bundle.

Modified: 2015-11-17