ADMINISTRATION PORTAL
Help Center User GuideGetting StartedFAQsRelease Notes
 
X
User Guide
Getting Started
FAQs
Release Notes
Contents  

SD-LAN Profiles Workflow

This section describes the workflow for SD-LAN profiles.

Before You Begin

Figure 27 depicts the workflow for adding SD-LAN profiles to CSO and assigning them to the EX Series switches.

Figure 27: Add Profiles Workflow

Add Profiles Workflow

To use profiles to configure EX Series switches, do the following:

  1. Add an authentication profile; see Add Authentication Profiles.

  2. Add firewall filters for egress and ingress traffic; see Add Firewall Filters.

  3. Add a port profile by assigning the authentication profile and the firewall filters; see Add Port Profiles.

  4. Add RADIUS Server profiles; see Add RADIUS Server Profiles.

  5. Add an access profile by using the RADIUS server profiles; see Add Access Profiles.

  6. Do one of the following:

    • If you are adding a site with a switch, assign the port profile and the access profile while adding the site; see Add an On-Premise Spoke Site with LAN Capability.

    • If the switch is already onboarded to CSO, edit the switch configuration to add the port profile and the access profile; see Configure an EX Series Switch by Using Profiles.

Help us to improve. Rate this article.
Feedback Received. Thank You!

Ask questions in TechWiki

Check documentation in TechLibrary

Rating by you:      
X

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:
Email:

Need product assistance? Contact Juniper Support

Submit