Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring SNMP

 

Use this procedure to configure SNMP community strings and trap receivers.

  1. Configure the community strings.Note

    In releases lower than release 4.3, you must have superuser privileges to provision SNMP community strings. In releases 4.3 and higher, you can provision SNMP community strings with the provisioning privilege.

    1. Configure the read-only community string.

      For example:

      bti7800(config)# snmp-server community RO password
    2. Configure the read-write community string.

      For example:

      bti7800(config)# snmp-server community RW password
    3. Display the new configuration.

      For example:

      bti7800(config)# do show running-config snmp-server community
  2. Configure the trap receiver.
    1. Specify the IP address of the trap receiver.

      For example:

      bti7800(config)# snmp-server host 10.1.1.1
    2. Repeat until you have configured all trap receivers.

    3. Display the trap receivers.

      For example:

      bti7800(config)# do show snmp host
Release History Table
Release
Description
In releases 4.3 and higher, you can provision SNMP community strings with the provisioning privilege.