show dol oms
Syntax
show dol oms[:identifier] [ detail | table ]
Description
This command shows information on all optical multiplex sections, or information on a particular optical multiplex section if a particular optical multiplex section is specified.
Options
Parameter | Description | Range |
|---|---|---|
oms:identifier | Displays information on the specified OMS | An existing
optical multiplex section (for example, |
detail | Displays information in detailed form | – |
table | Displays information in tabular form. This is the default | – |
Required Privilege Level
Related Documentation
Sample Output
The following output has been truncated for clarity.
bti7800# show dol oms Dynamic Optical Layer Optical Multiplex Sections ------------------------------------------------ Oms Name Admin State Oper State PRE State OL Id Custo ------------- ----------- ---------- -------------- ----- ----- oms:1/5/0/C1 enabled unknown Not Applicable oms:1/5/0/L1 enabled unknown disabled oms:1/6/0/C1 enabled unknown Not Applicable oms:1/6/0/C2 enabled unknown Not Applicable oms:1/6/0/L1 enabled unknown disabled oms:1/8/0/C1 enabled unknown Not Applicable oms:1/8/0/C2 enabled unknown Not Applicable oms:1/8/0/L1 enabled unknown disabled oms:1/9/0/C1 enabled unknown Not Applicable oms:1/9/0/C2 enabled unknown Not Applicable oms:1/9/0/L1 enabled unknown disabled