Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Optical Modules

 

Terminal Amplifier Module

The 96-Channel Amplifier (AMP1) is a terminal amplifier module that integrates two erbium-doped optical amplifiers to provide bidirectional amplification of the composite DWDM signal in a point-to-point bookended configuration. The amplifier is optimized for 10-Gbps, 25-Gbps, and 100-Gbps signals, and includes an embedded optical supervisory channel (OSC) used for span loss control.

Provisioning a Terminal Amplifier Module

Use this procedure to add a terminal amplifier module to a chassis. An example of a terminal amplifier is the 96-Channel Amplifier.

If auto-provisioning is enabled and you do not want to pre-provision, then you can skip this procedure because the system automatically provisions the terminal amplifier module when you insert the terminal amplifier module into the chassis.

  1. Enter configuration mode.
    bti7800# config
  2. Add the amplifier module.

    For example, the following adds an amplifier module to chassis 1 slot 11:

    bti7800(config)# equipment chassis:1 module amp:1/11
  3. Specify the PEC.

    For example, to specify the 96-Channel Amplifier:

    bti7800(config-module-amp:1/11)# pec BT8A78AMP1
  4. Apply the provisioning.
    bti7800(config-module-amp:1/11)# commit

Wavelength Protection Switch Module

The Wavelength Protection Switch (WPS4) provides four independent 1+1 revertive and non-revertive optical protection switches. It can be deployed with a variety of equipment including ROADM elements and non-equalizing terminal amplifiers.

Provisioning a WPS Module

Use this procedure to add a WPS module to a chassis.

If auto-provisioning is enabled and you do not want to pre-provision, then you can skip this procedure because the system automatically provisions the WPS module when you insert the WPS module into the chassis.

  1. Enter configuration mode.
    bti7800# config
  2. Add the WPS module.

    For example, to provision a WPS module in chassis 1 slot 12:

    bti7800(config)# equipment chassis:1 module wps:1/12
  3. Specify the PEC.

    For example, to specify a WPS4 module:

    bti7800(config-module-wps:1/12)# pec BT8A78WPS4
  4. Apply the provisioning.
    bti7800(config-module-wps:1/12)# commit