Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring the Individual Management IP Addresses

 

Use this procedure to configure the individual management IP address on a CMM. This is optional. You do not normally need to connect to the individual management IP address. Use of the individual management IP address is beyond the scope of this document.

Prerequisites:

  • The shared management IP address (and subnet) and the default gateway must be set up.

Each CMM has its own IP address that you can explicitly connect to if required. These individual management IP addresses are typically set up during commissioning.

Note

The individual management IP addresses, the shared management IP address, and the default gateway must all reside on the same subnet.

  1. Enter system configuration mode.

    For example:

    bti7800# config
  2. Set the individual management IP address for the CMM in slot A.

    All management IP addresses must reside on the same subnet.

    For example:

    bti7800(config-system)# controller-1 static-address 10.1.220.189
  3. Set the individual management IP address for the CMM in slot B.

    All management IP addresses must reside on the same subnet.

    For example:

    bti7800(config-system)# controller-2 static-address 10.1.220.190
  4. Commit your changes.
    bti7800(config-system)# commit
  5. Verify your settings by displaying the new settings.

    For example:

    bti7800# show system mgmt-interface