Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Configuring Auto-Warm-Boot

 

Use this procedure to configure auto-warm-boot. It is recommended that you leave this setting at its default value.

When auto-warm-boot is enabled, the active CMM automatically warm reloads a service module and/or a standby CMM up to 3 times if the service module and/or standby CMM is unresponsive.

Warm reloading modules does not affect traffic.

  1. Enter configuration mode for the system parameters.
    bti7800# config
  2. Specify whether auto-warm-boot is enabled or disabled.
    1. To enable auto-warm-boot for all modules (service modules and standby CMM):

      bti7800(config-system)# no auto-warm-boot disabled
    2. To disable auto-warm-boot for all modules (service modules and standby CMM):

      bti7800(config-system)# auto-warm-boot disabled ALL
    3. To disable auto-warm-boot for service modules:

      bti7800(config-system)# auto-warm-boot disabled PLD
    4. To disable auto-warm-boot for CMMs:

      bti7800(config-system)# auto-warm-boot disabled CMM
    5. Use a combination of commands to achieve other outcomes.

      For example, to enable auto-warm-boot for service modules only:

      bti7800(config-system)# no auto-warm-boot disabled
  3. Commit your changes.
    bti7800(config-system)# commit