system upgrade firmware
Syntax
Release Information
This command was introduced prior to release 2.1.1.
Starting with release 4.3, you can issue this command with the provisioning privilege. In releases lower than release 4.3, you must have superuser privileges to issue this command.
Starting with release 4.3, this command can be used to upgrade the re-timer firmware.
Description
This command performs operations related to firmware upgrades.
Options
Parameter | Description | Range | Default Value |
---|---|---|---|
ipmc module module_id | Upgrades the ipmc firmware on the specified traffic module. | See equipment chassis module for the correct syntax for module identifiers. | None |
l2-switch chassis_id | Upgrades the l2-switch firmware on the CMM. | A valid chassis identifier (for example, chassis:1) | None |
shmm chassis_id | Upgrades the shmm firmware on the CMM. | A valid chassis identifier (for example, chassis:1) | None |
force | Forces an ipmc firmware upgrade. | – | – |
retimer module module_id | Specifies the containing UFM6 module for re-timer firmware upgrade. | See equipment chassis module for the correct syntax for module identifiers. The module identifier must refer to a UFM6 module. | None |
port port | Upgrades the re-timer firmware on the specified dual-mode port. You can upgrade a specific dual-mode port or you can upgrade all dual-mode ports within the containing UFM6. You must change the admin-status of the transceiver to down before you can upgrade the re-timer firmware on the associated port. If you use the all option, you must change the admin-status of all1 dual-mode transceivers to down before you can issue this command successfully. If the admin-status of any dual-mode transceiver is up, this command with the all option is rejected. This command does not affect service on ports (dual-mode or otherwise) that are not being upgraded. | The following are the valid values:
| None |
1 If one or more of the dual-mode ports has already been upgraded and is carrying traffic, you should not use the all option because the all option requires you to disable all dual-mode transceivers regardless of whether they have been upgraded or not. |
Required Privilege Level
Sample Output
bti7800# system upgrade firmware shmm chassis:1
For more information on performing firmware upgrades, see the BTI7800 Series Software Configuration Guide.