Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    EqptFail

    Table 1: Alarm Details.

    Parameter

    Description

    Code

    eqptFail

    Description/Cause

    Equipment Failure:

    • A hardware self-test has detected faulty equipment.
    • An automatic upgrade of the re-timer firmware has failed on a UFM6.

    Entities Affected

    • Equipment (see respective table below).
    • Management and traffic modules (see respective table below).
    • Pluggable transceivers (see respective table below).

    Default Severity

    Critical

    Service Affecting

    Yes (true).

    Alarm Clearing

    See Clearing an EqptFail alarm.

    Related Fault Hierarchy

    See Equipment fault hierarchy.

    Table 2: Equipment

    Entity Name

     

    Fault Indicator

    Equipment

    Indicator

    Status

    cap:<chassis>/<slot>

    CAP

    See equipment specifications in the BTI7800 Series Hardware Overview and Installation Guide.

    fan:<chassis>/<slot>

    Cooling module

    esl:<chassis>/<slot>

    ESL

    pem:<chassis>/<slot>

    PEM

    Entity Name

     

    Fault Indicator

    Module

    Indicator

    Status

    cmm:<chassis>/<slot>

    CMM

    See BTI7800 Series Module and BIC LED Behavior.

    ufm:<chassis>/<slot>

    UFM

    bic:<chassis>/<slot>/<subslot>

    BIC

    roadm:<chassis>/<slot>

    ROADM2

    ila:<chassis>/<slot>

    ILA

    amp:<chassis>/<slot>

    AMP1

    wps:<chassis>/<slot>

    WPS4

    Table 4: Pluggable Transceivers

    Entity Name

     

    Fault Indicator

    Transceiver

    Indicator

    Status

    <transceiver-type>:<chassis>/<slot>/<subslot>/<port>

    where transceiver-type corresponds to the type of transceiver installed in the port; for example, cfp, qsfp, qsfp28, or sfpPlus.

    CFP, QSFP+, QSFP28, SFP+

    Fail LED, transceiver port

    On

    pre:<chassis>/<slot>

    PRE

    Fail LED, PRE port

    Clearing an EqptFail Alarm

    Note: Follow all applicable safety requirements as described in the BTI7800 Series Hardware Overview and Installation Guide.

    Note: Refer to the BTI7800 Series Hardware Overview and Installation Guide before reseating (removing and reinstalling) or replacing equipment.

    1. Perform a cold reload (system reload cold) of the failed equipment.
    2. Check for alarms.
      • If the alarm has cleared, you have completed this procedure.
      • If the alarm does not clear, go to the next step.
    3. Reseat the equipment (equipment, traffic module, or pluggable transceiver).
    4. Check for alarms.
      • If the alarm has cleared, you have completed this procedure.
      • If the alarm does not clear, go to the next step.
    5. Replace the equipment.
    6. Check for alarms on the equipment.
      • If the alarm has cleared, you have completed this procedure.
      • If the alarm does not clear, contact your next level of support.

    Modified: 2017-10-26