Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Configuring Auto-Reprovisioning

    Use this procedure to configure auto-reprovisioning.

    Auto-reprovisioning enables you to replace one module with a different module without requiring you to perform manual reconfiguration. This is currently supported for certain UFM modules. See Replacing a UFM3 or a UFM4.

    1. Enter configuration mode.

      For example:

      bti7800# config
      bti7800(config)# 
    2. Specify whether auto-reprovisioning is enabled or disabled.

      If auto-reprovisioning is enabled, the system automatically unprovisions the module being replaced, and provisions the newly inserted module. If auto-reprovisioning is disabled, you must manually unprovision the module being replaced, and manually provision the newly inserted module.

      For example, to enable auto-reprovisioning:

      bti7800(config-system)# auto-reprov true
      bti7800(config-system)# 
    3. Commit your changes.
      bti7800(config-system)# commit
      bti7800(config-system)# 

    Modified: 2017-07-06