TechLibrary

Table of Contents

Guide That Contains This Content

[+] Expand All

[-] Collapse All

EqptMism

Table 1: Alarm Details

Parameter	Description
Code	eqptMism
Description/Cause	Equipment Mismatch: The installed equipment does not match the equipment provisioned for the slot or subslot.
Entities Affected	Equipment (see respective table below). Traffic modules (see respective table below). Pluggable transceivers (see respective table below).
Default Severity	Critical
Service Affecting	Yes (true).
Alarm Clearing	See Clearing an EqptMism alarm.
Related Fault Hierarchy	See Equipment fault hierarchy.

Table 2: Equipment

Entity Name		Fault Indicator
Entity Name	Equipment	Indicator	Status
fan:<chassis>/<slot>	Cooling module	See equipment specifications in the BTI7800 Series Hardware Overview and Installation Guide.
esl:<chassis>/<slot>	ESL
pem:<chassis>/<slot>	PEM

Table 3: Traffic Modules

Entity Name		Fault Indicator
Entity Name	Module	Indicator	Status
ufm:<chassis>/<slot>	UFM	See BTI7800 Series Module and BIC LED Behavior.
bic:<chassis>/<slot>/<subslot>	BIC
roadm:<chassis>/<slot>	ROADM2
ila:<chassis>/<slot>	ILA
amp:<chassis>/<slot>	AMP1
wps:<chassis>/<slot>	WPS4

Table 4: Pluggable Transceivers

Entity Name		Fault Indicator
<transceiver-type>:<chassis>/<slot>/<subslot>/<port> where transceiver-type corresponds to the type of transceiver installed in the port; for example, cfp, qsfp, qsfp28, or sfpPlus.	CFP, QSFP+, QSFP28, SFP+	Fail LED, transceiver port	On

Entity Name

Fault Indicator

Transceiver

Indicator

Status

<transceiver-type>:<chassis>/<slot>/<subslot>/<port>

where transceiver-type corresponds to the type of transceiver installed in the port; for example, cfp, qsfp, qsfp28, or sfpPlus.

CFP, QSFP+, QSFP28, SFP+

Fail LED, transceiver port

Note: Follow all applicable safety requirements as described in the BTI7800 Series Hardware Overview and Installation Guide.

Note: Refer to the BTI7800 Series Hardware Overview and Installation Guide before replacing equipment.

Retrieve equipment-provisioning information:
show equipment
Do one of the following:
- Modify the provisioned settings so that they match those of the installed equipment (equipment, traffic module, or pluggable transceiver). For information, see the BTI7800 Software Configuration Guide.
- Replace the equipment with equipment that matches the provisioned settings.
Check for alarms on the equipment.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, contact your next level of support.