TechLibrary

Table of Contents

Guide That Contains This Content

[+] Expand All

[-] Collapse All

EqptFail

Table 1: Alarm Details.

Parameter	Description
Code	eqptFail
Description/Cause	Equipment Failure: A hardware self-test has detected faulty equipment.
Entities Affected	Equipment (see respective table below). Management and traffic modules (see respective table below). Pluggable transceivers (see respective table below).
Default Severity	Critical
Service Affecting	Yes (true).
Alarm Clearing	See Clearing an EqptFail alarm.
Related Fault Hierarchy	See Equipment fault hierarchy.

Table 2: Equipment

Entity Name		Fault Indicator
Entity Name	Equipment	Indicator	Status
cap:<chassis>/<slot>	CAP	See equipment specifications in the BTI7800 Series Hardware Overview and Installation Guide.
fan:<chassis>/<slot>	Cooling module
esl:<chassis>/<slot>	ESL
pem:<chassis>/<slot>	PEM

Table 3: Management and Traffic Modules

Entity Name		Fault Indicator
Entity Name	Module	Indicator	Status
cmm:<chassis>/<slot>	CMM	See BTI7800 Series Module and BIC LED Behavior.
ufm:<chassis>/<slot>	UFM
bic:<chassis>/<slot>/<subslot>	BIC
roadm:<chassis>/<slot>	ROADM2
ila:<chassis>/<slot>	ILA
amp:<chassis>/<slot>	AMP1
wps:<chassis>/<slot>	WPS4

Table 4: Pluggable Transceivers

Entity Name		Fault Indicator
<transceiver-type>:<chassis>/<slot>/<subslot>/<port> where transceiver-type corresponds to the type of transceiver installed in the port; for example, cfp, qsfp, qsfp28, or sfpPlus.	CFP, QSFP+, QSFP28, SFP+	Fail LED, transceiver port	On
pre:<chassis>/<slot>	PRE	Fail LED, PRE port

Entity Name

Fault Indicator

Transceiver

Indicator

Status

<transceiver-type>:<chassis>/<slot>/<subslot>/<port>

where transceiver-type corresponds to the type of transceiver installed in the port; for example, cfp, qsfp, qsfp28, or sfpPlus.

CFP, QSFP+, QSFP28, SFP+

Fail LED, transceiver port

pre:<chassis>/<slot>

PRE

Fail LED, PRE port

Note: Follow all applicable safety requirements as described in the BTI7800 Series Hardware Overview and Installation Guide.

Note: Refer to the BTI7800 Series Hardware Overview and Installation Guide before reseating (removing and reinstalling) or replacing equipment.

Perform a cold reload (system reload cold) of the failed equipment.
Check for alarms.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, go to the next step.
Reseat the equipment (equipment, traffic module, or pluggable transceiver).
Check for alarms.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, go to the next step.
Replace the equipment.
Check for alarms on the equipment.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, contact your next level of support.