EqptComm
Table 1: Alarm Details
Parameter | Description |
|---|---|
Code | eqptComm |
Description/Cause | Equipment Management Communications Failure: The CMM is not able to communicate with the equipment. |
Entities Affected | Traffic modules (see respective table below). |
Default Severity | Major |
Service Affecting | Depends on reason alarm has been raised. |
Alarm Clearing | |
Related Fault Hierarchy |
Table 2: Management and Traffic Modules
Entity Name | Fault Indicator | ||
|---|---|---|---|
Module | Indicator | Status | |
cmm:<chassis>/<slot> | CMM | ||
ufm:<chassis>/<slot> | UFM | ||
roadm:<chassis>/<slot> | ROADM2 | ||
ila:<chassis>/<slot> | ILA | ||
amp:<chassis>/<slot> | AMP1 | ||
wps:<chassis>/<slot> | WPS4 | ||
Clearing an EqptComm Alarm
 | Note: Follow all applicable safety requirements as described in the BTI7800 Series Hardware Overview and Installation Guide. |
| Note: Refer to the BTI7800 Series Software Configuration Guide before rebooting an active CMM. |
- Perform a warm reboot of the active CMM, and then
check for alarms on the affected module.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, go to the next step.
- Perform a cold reboot of the active CMM, and
then check for alarms on the affected module.
- If the alarm has cleared, you have completed this procedure.
- If the alarm does not clear, contact your next level of support.
