E–series Broadband Remote Access Server Configuration Basics

Course No: EDU-JUN-BB

Length: 4 days

Cost: $2,400 (US)

> Register

Course Overview

This course is designed to provide technical network professionals with the skills needed to successfully install, configure, and troubleshoot the E-series platform to act as a broadband remote access server (B-RAS). The course covers the fundamentals of B-RAS, ATM, IP over ATM, bridged Ethernet, PPP over ATM, PPP over Ethernet, VLANs, dynamic interfaces, L2TP, policy management as well as E-series router systems administration.

Objectives

After successfully completing this course, you should be able to:

• Configure IP-over-ATM interfaces;
• Configure bridged Ethernet interfaces;
• Configure PPP-over-ATM interfaces;
• Configure PPP-over-Ethernet interfaces;
• Configure dynamic interfaces;
• Configure L2TP;
• Troubleshoot connectivity issues;
• Configure fundamental policy management; and
• Describe E-series router system administration tasks.

Intended Audience

This course is intended for technical network professionals responsible for the integration, configuration, and management of E-series router networks.

Course Level

This is an intermediate-level course designed to provide a strong foundation for configuring the B-RAS application on an E-series router.

Prerequisites

The prerequisites for the E-series B-RAS Configuration Basics course are knowledge of IP in an ISP environment and the Introduction to Juniper Networks Routers-E-series course.

Course Contents

Day 1

Chapter 1: Course Introduction

Chapter 2: DSL Overview and IP over ATM

• B-RAS and DSL Overview
• IP-over-ATM Operation and Configuration
• Troubleshooting IP over ATM
• Lab 1: Configuring IP over ATM

Chapter 3: Bridged Ethernet and DHCP

• Overview of Bridged Ethernet
• Bridged Ethernet and DHCP Configuration and Troubleshooting
• Lab 2: Configuring Bridged Ethernet

Day 2

Chapter 4: PPP over ATM

• Overview of PPP over ATM
• Life of a Packet PPP over ATM
• Configuring PPP over ATM
• Troubleshooting PPP-over-ATM Interfaces
• Lab 3: Configuring PPP over ATM

Chapter 5: PPP over Ethernet

• Overview of PPP over Ethernet
• PPP over Ethernet in Ethernet Access Networks
• PPP-over-Ethernet Configuration and Troubleshooting
• Lab 4: Configuring PPP over Ethernet

Day 3

Chapter 6: Dynamic Interfaces

• Dynamic PPP-over-ATM and PPP-over-Ethernet Interfaces
• Dynamic IP-over-ATM and Bridged Ethernet Interfaces
• Dynamic Interface Creation Using Bulk Configuration
• Dynamic Subscriber Interfaces
• Lab 5: Configuring Dynamic Interfaces

Chapter 7: L2TP

• L2TP Overview
• L2TP Operation
• E-series Router L2TP Configuration
• L2TP Tunnel Failover and Tunnel Selection
• E-series Router Requirements
• Troubleshooting L2TP
• Lab 6: Configuring L2TP

Day 4

Chapter 8: Policy Management Overview

• Configuring Classifier Lists and Policy Lists
• Configuring Rate-Limit Profiles
• Configuring Policy Lists with Multiple Rules
• Troubleshooting Policies on the E-series Router
• Lab 7: Configuring Policy

Chapter 9: System Administration

• Upgrading and Downgrading Software
• Backup Boot Configuration and Slot Configuration
• Rebuilding Flash Cards and Password Removal
• Solutions 1 and 2
• Accessing the CLI
• Other System Administration Tasks