Known Problems
This section lists the known problems in Release 7.3.1.
- An error message appears when an update is performed on an E320 line module with only one IOA present and online. The message states that the other IOA is not online. Clicking OK completes the update of the line module and the IOA.
- When you use Add/Remove Programs in Windows to remove the Juniper Networks NMC-RX application, all Config Sync Services are also removed. However, entries for the Config Sync Services still appear in the Add/Remove Programs dialog box.
Workaround: Close, then reopen the Add/Remove Programs dialog box to refresh it and confirm that the Config Sync Services entries no longer appear.
- An SNMP error occurs when you try to configure an IP static route and select a nonbroadcast multiaccess (NBMA) or broadcast IP interface as the next hop. Only IP interfaces with a category of point-to-point can be used as the next hop for an IP static route.
- IP interfaces that you choose for any forward or next interface rules within a policy list must exist on the same virtual router. An SNMP error occurs if you add a forward or next interface rule to the policy list that specifies an IP interface from a different virtual router.