Known Limitations
This section lists the known limitations in Release 6.1.1:
- When you click Install on the Pre-Install Summary dialog box during installation, there is a short amount of time when the database updates. If you click Cancel during this time, the database remains locked for the installation of additional Config Sync Services.
Recommendation: Do not click Cancel after the installation begins. Instead, allow the installation to complete, and then use the NMC-RX Uninstaller or Config Sync Services uninstaller to remove the desired components.
- When you use Bulk Services to create a large number of objects, limit the number of objects to a maximum of 9000. Otherwise, you run the risk of running out of memory. To create additional objects, you can exit the NMC-RX application and then restart.
- Currently, the NMC-RX application allows you to start multiple Polling Services at the same time. Only one Polling Service is actually used by the application. There will be no disruption of service if you start additional services; however, it is a waste of resources to do so, and currently no error message is displayed to indicate any displacement of the service being used. All instances of polling should be closed, and only one restarted.
- When the Config Sync Services and the Polling Service are started before the database has completely initialized, an error occurs.
Recommendation: Wait until the database is initialized before launching other NMC-RX components. If an error has occurred, close all NMC-RX components (including the database) and start over.
- If you edit the Integrated Local Management Interface (ILMI) settings (virtual path identifier [VPI] and virtual circuit identifier [VCI]) of an ATM interface while the ILMI Settings Admin Status is set to "Up," an SMNP error occurs.
Workaround: Before changing VPI and VCI settings, change the ILMI Settings Admin Status to "Down," and click Save. Next, update the VPI and VCI settings, and click Save. Then, change the ILMI Settings Admin Status back to "Up," and click Save.
- An error may occur if, during a device update, you attempt to make changes to a scheduled task and save them.
Workaround: Wait until the device has been updated, and then edit the scheduled tasks.