Known Problems
This section lists the known problems in Release 6.1.1:
- When you use Add/Remove Programs in Windows to remove the Juniper Networks NMC-RX application, all Config Sync Services are also removed. However, entries for the Config Sync Services still appear in the Add/Remove Programs dialog box.
Workaround: Close, then reopen the Add/Remove Programs dialog box to refresh it and confirm that the Config Sync Services entries no longer appear.
- When statistics are running, if an SNMP error is received on another operation (create, for instance) and you do not click the OK button on the error message dialog box within a certain number of seconds, an SNMP timeout error is returned for the SNMP statistics get request. The same result occurs if the SNMP error is on one device and the statistics polling is occurring on another.
After you click OK on the error dialog box, everything returns to normal with the next poll.
- When configuring an interface, if you display the Module Config tab (by clicking the Lower Layer button) and then close it (by clicking the X button), all other tabs are closed and the original interface remains locked.
Workaround: Users with Security privileges enabled can right-click the System folder and choose Unlock Device.
- An SNMP error occurs when you try to configure an IP static route and select a nonbroadcast multiaccess (NBMA) or broadcast IP interface as the next hop. Only IP interfaces with a category of point-to-point can be used as the next hop for an IP static route.
- IP interfaces that you choose for any forward or next interface rule within a policy list must exist on the same virtual router. An SNMP error occurs if you add a forward or next interface rule to the policy list that specifies an IP interface from a different virtual router.