Configuring JUNOScope System Log Output

The JUNOScope system log output is enabled during installation by default.

During the JUNOScope installation process, the installer is prompted for the following:

Please enter the syslog facility (local0-local7) [local2]:

The syslog facility indicates a pipe where the syslog daemon (syslogd) sends the JUNOScope software system log messages that it receives. The administrator can enter the values local0, local1, local2, local3, local4, local5, local6, or local7 that correspond to a logging facility. The default is local2, which is logging facility 2.

The JUNOScope administrator can change the syslog facility at any time by reconfiguring JUNOScope using the jtk-setup.sh script.