You can configure rate limiting for voice calls on the virtual
BGF by setting default, minimum, and maximum values for properties
defined in the H.248 traffic management package. The virtual BGF uses
the default values unless the gateway controller overrides them with
an H.248 command. You can configure maximum and minimum values if
you want to limit the range of values accepted from the gateway controller.
Parameters for the RTCP stream take effect only when the gate is an
RTP/RTCP gate. You can configure peak and sustained data rates for
the RTCP stream as a set rate or as a percentage of the corresponding
RTP data rate.
The traffic management package is defined in Annex C of Gateway control protocol v3, ITU-T Recommendation H.248.53, —
June 2008.
Step-by-Step Procedure
To configure rate limiting for the gate stream and the RTCP
stream:
Access the configuration of the H.248 traffic-management
properties.