System Requirements for Dual PIM Multicast VPNs: Draft Rosen
JUNOS Release 8.2 or later for support on MX-series routing
platforms.
JUNOS Release 7.2 or later for MSDP in a Layer 3
VPN.
JUNOS Release 7.1 or later for multicast distribution
trees for data.
JUNOS Release 6.4 or later for PIM sparse mode graceful
restart and configuring a PE router as the VPN C-RP.
JUNOS Release 5.5 or later for PIM dense mode and logical
loopback interfaces.
JUNOS Release 5.3 or later for PIM sparse mode.
Any hardware needed in your network to enable your Juniper
Networks routers to act as PE routers.
On M-series and T-series routers, a Tunnel Services PIC
or for any provider core router acting as an SP-RP.
On M-series and T-series routers, a Tunnel Services PIC
for any PE router where GRE tunneling is needed.
On M-series and T-series routers, a Tunnel Services PIC
for any CE or PE router acting as a DR or VPN C-RP.
On M-series and T-series routers, a Tunnel Services PIC
is required for GRE tunneling, as specified in Section Two of the
IETF Internet draft Multicast in MPLS/BGP
VPNs.
For point-to-multipoint TE, a Tunnel Services PIC or vrf-tabel-label
configuration.
