[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Configuring Protocol Family and Address Interface Properties

For each logical interface, you must configure one or more protocol families. You can also configure interface address properties. To do this, include the following statements:

family family {
accounting {
destination-class-usage;
source-class-usage {
direction;
}
}
filter {
dialer filter-name;
input filter-name;
output filter-name;
group filter-group-number;
}
llc2 {
ack-delay-time time;
ack-max count;
idle-time time;
local-window count;
max-retry count;
p-bit-timeout time;
redundancy-group group-number {
advertise-interval seconds;
map {
local-mac mac-address remote-mac mac-address;
preempthold-time seconds;
no-preempt;
priority priority;
track {
dlsw {
destination mac-address priority-cost priority;
peer ip-address priority-cost priority;
}
interface interface-name priority-cost priority;
}
}
t1-time time;
t2-time time;
trej-time time;
}
keep-address-and-control;
mtu bytes;
multicast-only;
no-redirects;
policer {
arp policer-template-name;
input policer-template-name;
output policer-template-name;
}
primary;
protocol [inet iso mpls];
proxy inet-address;
receive-options-packets;
receive-ttl-exceeded;
remote (inet-address | mac-address);
rpf-check <fail-filter filter-name> {
<mode loose>;
}
(translate-discard-eligible | no-translate-discard-eligible);
(translate-fecn-and-becn | no-translate-fecn-and-becn);
unnumbered-address interface-name <destination address destination-profile profile-name>;
address address {
arp ip-address (mac | multicast-mac) mac-address <publish>;
broadcast address;
destination address;
destination-profile name;
eui-64;
multipoint-destination address (dlci dlci-identifier | vci vci-identifier);
multipoint-destination address {
epd-threshold plp1 cells;
inverse-arp;
oam-liveness {
up-count cells;
down-count cells;
}
oam-period (seconds | disable);
shaping {
(cbr rate | rtvbr peak rate sustained rate burst length | vbr peak rate sustained rate burst length);
queue-length number;
}
vci vpi-identifier.vci-identifier;
}
preferred;
primary;
vrrp-group group-number {
(accept-data | no-accept-data);
advertise-interval seconds;
authentication-key key;
authentication-type authentication;
fast-interval milliseconds;
(preempt | no-preempt) {
hold-time seconds;
}
priority number;
track {
priority-hold-time;
interface interface-name {
priority-cost priority;
bandwidth-threshold bits-per-second {
priority-cost;
}
}
}
virtual-address [ addresses ];
}
}
}
}
}

You can include these statements at the following hierarchy levels:

For information about interface-specific protocol and address properties, see Configuring T1 and NxDS0 Interfaces.

This chapter describes the configuration of the interface protocol and address properties:

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]