Configuring the Interface Address

To configure the logical address for the MLPPP bundle, include the address statement:

address address {

...

}

You can configure this statement at the following hierarchy levels:

• [edit interfaces interface-name unit logical-unit-number family inet]
• [edit logical-routers logical-router-name interfaces interface-name unit logical-unit-number family inet]

Assign an IP address to the interface by configuring the address value. The AS or MultiServices PIC supports only IP version 4 (IPv4) addresses configured using the family inet statement.

For information on other addressing properties you can configure that are not specific to service interfaces, see the JUNOS Network Interfaces Configuration Guide.