[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

PPPoE Interface Operational Mode Commands

Table 43 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Point-to-Point Protocol over Ethernet (PPPoE) interfaces. Commands are listed in alphabetical order.

Table 43: PPPoE Interfaces Operational Mode Commands

Task

Command

Clear PPPoE sessions.

clear pppoe sessions

Clear PPPoE session statistics.

clear pppoe statistics

Display interface-specific information about PPPoE-configured interfaces.

show interfaces (PPPoE)

Display session-specific information about PPPoE-configured interfaces

show pppoe interfaces

Display PPPoE session statistics.

show pppoe statistics

Display PPPoE version information.

show pppoe version

Note: PPPoE interfaces are supported on Fast Ethernet and ATM-over-ADSL and ATM-over-SHDSL interfaces on the J-series routing platform only. PPPoE interfaces connect multiple hosts on an Ethernet LAN to a remote site through a J-series Services Router. Hosts share a common digital subscriber line (DSL), a cable modem, or a wireless connection to the Internet. For information about how to configure PPPoE interfaces, see the J-series Services Router Basic LAN and WAN Access Configuration Guide or the JUNOS Network Interfaces Configuration Guide.

Note: For information about monitoring and troubleshooting Fast Ethernet interfaces, see Ethernet Interface Operational Mode Commands.

Note: For information about monitoring and troubleshooting ATM-over-ADSL and ATM-over-SHDSL, interfaces, see ATM Interface Operational Mode Commands.

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]