Checking Your Work

To verify that your dynamic flow capture configuration is operating correctly, issue the following command:

show services dynamic-flow-capture capture-group group-name control-source 
source-identifier source-id (detail)

The following section shows the output of this command when used with the configuration example.

Router 1

user@router1> show services dynamic-flow-capture control-source capture-group g1 
source-identifier cs2 detail

Capture group: g1, Control source: cs2

  Criteria added: 1, Criteria add failed: 0

  Active criteria: 2

    Static criteria: 0, Dynamic criteria: 2

  Control protocol requests: 3

                     Add        Delete          List       Refresh         No-op

    Requests           1             0             1             0             1

    Failed             0             0             0             0             0

  Add request rate: 0

  Add request peak rate: 1

  Bandwidth across all criteria: 0

  Total notifications: 0

    Restart: 0, Rollover: 0, No-op: 0, Timeout: 0, Congestion: 0, Congestion 
delete: 0,

    Dups dropped: 0

  Criteria deleted: 0

    Timeout idle: 0, Timeout total: 0, Packets: 0, Bytes: 0

  Sequence number: 242

To clear statistics for dynamic flow capture, issue the clear services dynamic-flow-capture command. For more information on other DFC-related operational mode commands, see the JUNOS System Basics and Services Command Reference.