[Contents] [Prev] [Next] [Index] [Report an Error]


Chassis Operational Mode Commands

From the command-line interface (CLI), you can display information about chassis components using the commands in the show chassis hierarchy. These commands get their information from the chassis software process, which runs when the router is up and running.

Table 10 summarizes the CLI commands you can use to monitor router chassis. In the table, the commands are grouped by functionality. In the remainder of this chapter, they are explained alphabetically.


Table 10: Commands for Monitoring Chassis
Task or Information to Monitor
CLI Command

Chassis alarm status

show chassis alarms

Chassis clock-source configuration

request chassis pcg

Information currently on craft display

show chassis craft-interface

Environmental information

request chassis cfeb
show chassis environment
show chassis environment cb
show chassis feb
show chassis cfeb
show chassis environment fpc
show chassis environment fpm
show chassis environment mcs
show chassis environment pcg
show chassis environment pem
show chassis environment routing-engine
show chassis environment scg
show chassis environment sfm
show chassis environment sib

Firmware version

show chassis firmware

FPC and PIC status

show chassis fpc
show chassis pic fpc-slot pic-slot
request chassis cfeb
request chassis fpc
request chassis pic

Hardware inventory

show chassis hardware

MAC address

show chassis mac-addresses

Routing Engine

show chassis routing-engine
request chassis routing-engine master

CB Ethernet switch information

show chassis ethernet-switch

FEB, CFEB, SCB, SFM, or SSB status

show chassis feb

show chassis cfeb
request chassis cfeb

show chassis scb

show chassis sfm
request chassis sfm
request chassis sfm master switch

show chassis ssb
request chassis ssb master switch

Information about the Switch Processor Mezzanine Board (SPMB)

show chassis spmb
show chassis spmb sibs

Change status

request chassis scg
request chassis sib
request chassis spmb restart slot

Display a message on the router's craft interface

set chassis display message



[Contents] [Prev] [Next] [Index] [Report an Error]