Configure Ethernet Interfaces
Ethernet was developed in the early 1970s at the Xerox Palo Alto Research Center as a data-link control layer protocol for interconnecting computers. It was first widely used at 10 Mbps over coaxial cables and later over unshielded twisted pairs using 10Base-T. More recently, 100Base-TX (Fast Ethernet, 100 Mbps), Gigabit Ethernet (1 Gbps), and 10-Gigabit Ethernet (10 Gbps) have become available.
Juniper Networks routing platforms support the following types of Ethernet interfaces:
- Fast Ethernet
- Gigabit Ethernet
- Gigabit Ethernet Intelligent Queuing (IQ)
- 10-Gigabit Ethernet
- Management Ethernet interface, which is an out-of-band management interface within the routing platform
- Internal Ethernet interface, which connects the Routing Engine to the Packet Forwarding Engine
- Aggregated Ethernet interface, a logical linkage of Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet physical connections
This chapter discusses the following topics specific to configuring the different types of Ethernet interfaces in the routing platform:
- Configure Ethernet Physical Interface Properties
- Configure 802.1Q VLANs
- Configure TCC and Layer 2.5 Switching
- Configure Static ARP Table Entries
- Configure VRRP
- Configure the Management Ethernet Interface
- Configure Gigabit Ethernet Accounting and Policing
- Display the Internal Ethernet Interface
- Configure Aggregated Ethernet Interfaces
For examples of Ethernet interface configuration, see the following sections: