Example: PPP to ATM TCC Configuration
![]()
In Figure 52, Router A uses PPP to connect with Router B, while Router C connects with Router B through ATM. Router B acts as the Layer 2 virtual switch and transparently connects Router A to Router C.
On Router A, configure basic PPP encapsulation and any desired Layer 3 protocol families on the SONET/SDH interface.
Router A
[edit]interfaces {so-0/1/0 {description "to Router B so-0/0/0";unit 0 {encapsulation ppp;family inet {address 1.1.1.1/30;}}}}Router B acts as the virtual Layer 2 switch. Here you configure the appropriate TCC encapsulations on the corresponding interfaces. In this case,
encapsulation ppp-tccis bound to physical interfaceso-0/0/0, andencapsulation atm-tcc-vc-muxis placed on VC 32 of interfaceat-1/1/0. Because the switching occurs at Layer 2, you cannot configure IP addresses or other Layer 3 family information on these interfaces.You also need to configure MPLS and establish the cross-connect by adding the necessary interfaces to the
interface-switchstatement at the[edit protocols connections]hierarchy level.Router B
[edit]interfaces {so-0/0/0 {description "to Router A so-0/1/0";encapsulation ppp-tcc;unit 0 {}at-1/1/0 {description "to Router C at-0/3/0";atm-options {vpi 0 maximum-vcs 2000;}unit 32 {vci 32;encapsulation atm-tcc-vc-mux;}}}protocols {mpls {interface so-0/0/0.0;interface at-1/1/0.32;}connections {interface-switch PPP-to-ATM {interface so-0/0/0.0;interface at-1/1/0.32;}}}On Router C, the encapsulation option used to connect to the TCC-encapsulated ATM interface on Router B is
atm-vc-mux. Since this ATM connection is switched at Layer 2 to reach the PPP link, it is transparent to Layer 3 addressing. As a result, the IP address must be configured in the same address space as Router A's so-0/1/0 interface.Router C
[edit]interfaces {at-0/3/0 {description "to Router B at-1/1/0";atm-options {vpi 0 maximum-vcs 2000;}unit 32 {vci 32;encapsulation atm-vc-mux;family inet {address 1.1.1.2/30;}}}}